English
Spanish
French
The LT HQY255-125 is a busduct bridge-housing extrusion and pressing machine for riveting busbar trunking joints. It assembles busbar rows 91 to 255 mm wide and 125 mm high, covering the 125 x 91 mm and 125 x 255 mm bridge sizes. Riveting, prefabricated and discharge tables work as one station, with pneumatic clamping over polyurethane rollers.
HQY255-125 Busduct Busway Bridge Housing Extrusion Pressing Clamping MachineFeat
Work range — The press is set for busduct bridge housings between 125 x 91 mm and 125 x 255 mm. The busbar row is installed, the riveting table pushed in and the assembly compressed, so the rivet positions are aligned before the manual riveting operation starts.
Clamping and surface protection — The top ram lifts the bridge clear of the rollers and both side clamps close before the copper is compacted; the non-powered rollers are polyurethane covered instead of bare steel, which keeps the bridge surface from being scratched during feed.
Station layout — Three tables - riveting, prefabricated and discharge - share a frame built from bent steel plate and square steel tube, with the rack surface sprayed grey. Frame height can be adjusted to suit the operator, and the top pressing device is bolted from 8 mm steel plate and guided by a guide block.
HQY255-125 Busduct Busway Bridge Housing Extrusion Pressing Clamping Machine
Features:
1. Use and requirements:The busbar press is equipped with three parts: riveting table, prefabricated table and discharge table. It is used for riveting assembly of busbar row of 91 ~ 255mm width and height of 125mm. After the busbar row is installed, push the riveting table and press Will be targeted after the compression to facilitate the artificial riveting.
2. With relay control, pneumatic clamping, no power roller with integral installation, roller surface covered with polyurethane, to prevent scratching the bridge. The frame steel beam is formed by bending the steel plate and is supported by the steel pipe of the square pipe, which can be adjusted according to the need, the rack surface spray (gray). The upper pressing device is made of bolts with 8mm steel plate as a whole and guided by guide block. Work will be pre-installed bridge to the appropriate position, depress the foot switch, the top material device to lift the bridge from the roller in place after the remain intact, both sides of the clamping device action clamping the bridge, the last pressure Tight device action will be copper compacted. After the completion of artificial riveting, step down the foot switch, the pressure on the rise, both sides of the pressure release, the top material device down the bridge to fall back to the roller surface, the bridge pushed out to the discharge station for follow-up operation.
Bridge processing requirements:
1, the bus press for 125 × 255mm and 125X91mm between the specifications of the bridge, before the riveting clamping operation.
2, Pre-installed part of the pneumatic block on the device.
Technical support:
Busbar press machine instructions:
Including safety warning, machine principle, performance parameters, pneumatic schematic diagram, accessory table, wiring table, safe operating procedures.
